Recent content by V8Vic

I bought a pair from him a couple of years ago. They fit fine and look great on my '32 tudor. "Dont have a phone but his e-mail was peteschumpert@gmail.com Hope this helps, Vic

Back in the late '80s, Rex Gardner and I had some problems with Kelsey and Ford wire wheels on our Great Race '35 coupe. Apparently, the wheels were just moving around enough to shred our new Coker tubes. Replaced them with a heavier tube from the Co-Op farm store and stopped the problem. I...

Sold, Please remove

Drop Price..…..now $975

Joe Casto south of Ponca City OK does a great job. He's done several for me and also does the spindles if you need. Joes Speed Shop 580-268-3704

Bttt … Offers?

'36 LB Engine, has about 25K miles, complete from pan to intake, will need water pumps, starter, ignition and exhaust manifolds. Was used in TSD Rally car, bored .030, Isky lifters, mild Crane cam. Not a Hot Rod motor, idles fine, ring and valve job should put it back to a good driving motor...

Try Gene French in Nunn CO (970)581-2808 I have spent about 30K miles in a '36 Coupe powered by a '36LB he rebuilt

Elwood, got a question about tank replacing, on a '34 Coupe, is it required to raise the body or just that "pan" above the tank when replacing ? This is for a pal, I'm a '32 guy myself. Vic

Sold

Bttt

Bttt

Bttt

JW Rod Shop '32 rails with bolted in Gennie '32 crossmembers (cleaned and primed) $2000, you pick up. also have JW boxing plates if you need them. Great start for Resto or Rod... rear X-membr trimmed to clear factory C-notch in JW rails. Vic 316 258 7103 SOLD

ROTERWRENCH, sorry it took me so long to get back to you. Rex is the owner, driver and mechanic , I'm just the "gofer" and the navigator on this project. Briefly, he uses 3/16" sleeves, the bore for these almost always results in going through to "air", he leaves a step edge on the bottom and...