Recent content by V8guy

Chrome vent fan has been re chromed and rewired with a modern fuse holder. Ran it in my 36 Ford and removed it before it was sold to install in the next car that never happened. $95.oo shipped to the lower 48 states.

1935 Fuel Oil gauge with oil sender. A repair was made on the sight glass tube I did fill the gauge with isopropyl alcohol and did not see any leaks. $90.00 shipped to the lower 48 states

I have a late 40s early 50s Sun Dist machine that I purchased in the 1970s the strobe is getting weak and will only flash at higher RPMs, every thing else works as it should. Suggestions for repair. Thanks Mike

Std. 09T pistons bead blasted with 8BA rods fitted with.005 oversized pins. were run for a short time had a bad block got another block but its .030 over so they are no longer needed. $90.00 + shipping.

Planning on doing a repair on my 1935 hydrostatic fuel gauge sender over this winter. Will the fuel soften the JB Weld if submerged in fuel tank has anyone used it for ruel system repairs ??

I have a 59A in my 35 it was a bolt in but i used the 35 intake manifold to properly support the fan mounted generator, and i used a radiator hose kit from Bob Drake. I will try to take a few photos and post them later.

The late 36 Flat top Dist uses the same points as the 37-48 and I believe the 11A parts fit

The car sat idle for a number of years when I purchased it, that was the condition of the sender when I removed it to clean the tank, At one time I had the gauge working it would only read 3/4 when full but empty was empty and I could live with that. In the last 2 years or so it started pushing...

What do the little cups on the sender do the lower one is pretty much gone see photos. Suggestions for repair? Mike

The fuel gauge is pushing the red fluid out the top of the glass tube in to the gauge. I have removed the gauge and cleaned it more than once and cleaned the sending unit last year. suggestions Mike

Has anyone tried Apple Cider Vinegar to clean the tank unit considering trying it on my 35, also suggestions for repairing the cups on the tank unit my upper one is partially rusted away. Mike

Has any one tried Apple cider vinegar I am considering trying it on me 35. i also need to repair the upper cup any suggestions Mike

Joe is the only one I have dealt with and there are many that took the time to call me if there was an issue with my order. He is one of the best .

Can anyone tell me what year this might fit doing spring garage cleaning or better known as moving parts from there to here. Mike

1935 sedan with a stock 59-AB using the 35 intake manifold. I have 3 cabs a 46-48 Ford 59 and a Stromberg 97 and a Stromberg 48. Not looking to go racing just a nice driver and best for fuel mileage as we like to do trips. I intend to rebuild one for the upcoming driving season.