Recent content by topchop

  1. topchop

    1947 Ford Super Deluxe Sedan

    sold
  2. topchop

    1947 Ford Super Deluxe Sedan

    Btt
  3. topchop

    1947 Ford Super Deluxe Sedan

    Btt
  4. topchop

    1947 Ford Super Deluxe Sedan

    Btt
  5. topchop

    1947 Ford Super Deluxe Sedan

    Btt
  6. topchop

    1947 Ford Super Deluxe Sedan

    Rebuilt correct 59AB motor, transmission, rear end (3:78 gears). New windshield glass, wiring, headliner, door panels, Arizona Diamondback WW tires, bumpers, lots more. Older paint, still looks great. Runs, drives excellent. Everything works, except clock. Recently used in filming movie in...
  7. topchop

    Crab Condenser relocation

    EdB, Coil is Napa part# ECH IC7 Condenser is Napa part# ECH FA54
  8. topchop

    Crab Condenser relocation

    Here's a picture.
  9. topchop

    Crab Condenser relocation

    I have seen on some previous posts, where they relocate the ('42 - '48) crab distributor condenser to an area up near the coil, in a more accessible area. Having the recent occasion(s) to replace my condenser (mounted on the distributor) along the roadside has made me think of that. Any...
  10. topchop

    Fighting a "missing then stall problem" when hot

    Mart, it is the "V" rabbit ear distrib. cap. Update: After having replaced the condenser with another "new" IH 200, it appears fixed. I say this because I spent 1/2 hour driving around the block (my neighbors now know I was having problems). Previously, that was enough for the symptom to show...
  11. topchop

    Fighting a "missing then stall problem" when hot

    Battling this for several weeks now with no resolution, only frustration. Basically, I am seeking an answer to a question at the bottom on this post. 59AB motor rebuilt 1 year ago. Ran fine. At time of rebuild: Bubba distributor, Charlie NY 94 carb, can style coil bypassing the resistor...
  12. topchop

    Banjo Bearing Lubrication Question

    19Fordy, nice homemade vent, should work well. Have used the grease on drill bits in the past successfully to avoid chips in tubes. Found these to work well as vents too...
  13. topchop

    Picture of Firewall needed

    Wire harness in, heater installed. Here are pictures of what I have come up with for the routing of the heater hoses. Behind the carburetor works best for me, for as I rotate the nipple towards the front of the carb, it interferes with the spark plug wire conduit. Those ugly chartreuse wire ties...
  14. topchop

    Picture of Firewall needed

    Slight detour before I install the heater. While I was under the dash, looking at the wires, man, noticed that they were in bad shape. Previous owner(s) patched here and there, and cut and spliced others. Decided to replace the harness. Much easier with no heater and radio (replaced the speaker...
  15. topchop

    One leaky head stud

    Wow! Professor Henry, after reading that thread all the way through, I just have to smile. You are still my hero.
Back
Top