Recent content by Tom Smith

Will we ever get to buy just the worm and sector only?

I found over the years Brattons carried the most accuretly dimeonsioned Roller and the head on the roller pin was correct. I stocked up when they went out of business.

Thank you to every ones input.

Getting ready to put a new motor in. I also have the transmission out from rebuilding it. Question I have is it a good or bad idea to install the motor and transmission together? I have never attempted this, your thoughts.

I always tape the terminals on after market switches, I also apply an insulating tape to that area of the gas tank. Tom

Very Interested. Also other videos to show at our meetings

Check out Lakeshore Model A Ford Club Web Site, based out of Rochester area.

Sounds like you may need to add the spacer to the cable, installed between the cable connections. I think it was Brattons that offers the new cable with this extra spacer included. I have installed one as I had the same problem. I also did the gear change as suggested, lasted for a short time...

Tam's sells best replacement oil

Thank you for your reply. I will be working on two Burtz motors and was options for Oil Pumps and to what pressures I can get. looks like you were able to get a comfortable pressure with Bill's Pump. I'm looking for possible other alternatives also to make a decision, also not knowing if Stipe...

Looking for detailed information for hot and cold pressures and at what RPM's. Also is Bill still in business, I see the web site does not work.

Thank you Skip. talked with Travis today.

Tried to call today, don't think his phone is working either.

Anyone with info. on Travis Cook from West Hartford, CT

Btt