Recent content by Super88

  1. Super88

    What is used here?

    Thanks for the responses.
  2. Super88

    What is used here?

    After reading the responses (thanks btw) I took a closer look and after blowing out some dirt, saw there is a slotted screw in each. My question now is should this be plugged with something like the driver's side or isn't it necessary? My concern is if leaving it unplugged, would be noticeable...
  3. Super88

    What is used here?

    Currently working on a 1930 Tudor. What is used in the two holes circled in the photo? The driver's side has a material in those holes, but I can't determine what it is.
  4. Super88

    Tudor seat question

    Thank you very much. That was much more detailed than I was expecting and will be very helpful.
  5. Super88

    Tudor seat question

    Thanks everyone for the replies. Dennis lumbert, could you provide a little more information about how you put the foam in the springs? Did you put foam in each turn of the coil or stuff it down the middle of the coil?
  6. Super88

    Tudor seat question

    Synchro909 it's definitely nasty stuff to work with. In some areas it was just wrapped around the top perimeter wire. In others it was wrapped around and then covered with a tubular clip that was squeezed around the wire and wrap.
  7. Super88

    Tudor seat question

    I'm currently working on a pair of front seats for a 1930 Tudor. It's obvious the seats have been either reupholstered or repaired in the past 96 years, due to finding staples and two different sizes of finishing nails, along with more tacks than necessary anchoring the fabric. On both bottom...
  8. Super88

    Pietenpol

    Every year in July there is a Pietenpol meet at the airport in Brodhead, WI.
  9. Super88

    29 Tudor door seal/bumpers/door glide clip

    I ordered a door bumper kit for my 1930 Tudor that was listed as being for 1930 and 1931. When trying to install them I found the brass clip was too long to fit in the pocket of the door. The depth of the pocket is 5/8 inch and the clips are 3/4 inch long. Looking at the photo in post #9, the...
  10. Super88

    Top Wood Hardware

    Disregard. I found help elsewhere.
  11. Super88

    Top Wood Hardware

    I'm finally getting some time to install the top wood in my 30 Tudor. In Les Andrews book on page 3-61 he lists a #10 lock washer used for the bow support rail, but on page 3-79 he states to install with 1/4 flat washer. Which is it?
  12. Super88

    Tudor Rear Seat Removal.

    Taking it out is easy. Putting it back in can be another story:)
  13. Super88

    Model A Day 2020 in Sharon WI Cancelled

    Needed to be done, but it will be greatly missed.
  14. Super88

    Henry Ford biography

    If you stream your TV programs and use Pluto the Henry Ford biography is on with interesting footage.
  15. Super88

    The 1930 Deluxe Tudor Sedan...

    You certainly couldn't "deluxe" one now days for $35.00, let alone $70.00:)
Back
Top