Recent content by streetdreams

Have 2 complete 9 inch rears out of ‘57 Fords for sale . One from retractable, one from convertible. $300 obo each

Ttt

sold

For sale one C1TE forged steel crankshaft for 292 Ford Y Block. Measures up standard on rods and mains. Journals are very good with no scratching, etc. Polishing may clean it right up, at worst 10/10. Asking $475 plus the ride. PM with any questions or if pictures wanted.

does drum rotate or are shoes rubbing drum on inside keeping drum from rotating?

ttt

ttt

ttt

ttt

Ttt

Ttt

Ttt

"will ADD 5-15 psi..."?? Could this be a misprint? Piping oil from the main galley to the rocker shafts will actually cause a drop in pressure. " No misprint. I always pressurize rocker assemblies on a Y Block. The spillover system from the factory is: 1) an oil leak directly to the oiling...

pressurizing your rocker arm assemblies will add 5-15 psi depending on what condition your oiling system/bearings are in.

Kultulz, not a problem. Actually, was quite proud to see one of my jobs used as a reference. Not sure, but believe '56 Merc was the same goldish/greenish white as the '55 block/heads.