Recent content by SteveInMissouri

Hi everyone, I am just getting a power train rebuild going on a 57 Merc 312. I seem to have a problem getting spark. I changed out the points to a Pertrinix module, and the recommended coil also. With the key off and grounding to the negative on the battery and checking the positive side of...

Well, as you and MercMan have shown me I am close on my wire routing but need to do a bit of work still.

Thank You, MercMan!

Thank You.

Hi, I am looking for a temp sensor and a oil pressure sending unit for a 1956 Mercury 312. Both are the ones that have the two contact blades coming out the top. I am able to find a temp sensor at Mac's but it is $51.00, seems a bit high to me. Anyway if someone has a good supply house I...

Well I installed the thing back there beside the distributor it for sure fit but it covers a bolt hole. and I am not sure if I may have it backwards or something. I attached a picture for a little advice if possible. Also, you know how one thing seems to lead to another. I have this crooked...

I checked the timing pointer and it fit right up, while there i took a couple pictures of the rear of the block behind the intake. Looks like a fit. hopefully I will be dropping it in soon to check out how it functions a little better. I'm still a little confused on that part.

Great thanks again, quite the puzzle....

I'm not sure about the horn mount. This came back to me in a box from the machine shop that did the engine so this was bolted to the engine somewhere i have to assume.

Thank You

Hello All, I am finishing up a 56 Mercury Montclair engine assembly, and it seems I have a couple of parts left over that I can't find a home for. I think that they are markers, probable one for a timing mark. But the truth is I just don't know. If someone could help me with identification...

Thank You!!!

Hi All, I am in the middle of a Merc Montclair power train project. I am finishing off all the pumps and bolt-ons, before dropping it in. I thought I was covered by taking a lot of pictures before I dis-assembled the thing. I guess I missed on taking some pictures of the motor mounts. They...

Well KULTULZ, I'm probably a bit on the clueless side of this so I appreciate the advice. I assume the pinion and axle seals have set and dried out and need replaced. I don't have any experience with replacing either of them, so I will need to get googled up on how to go about it. I know it...

Thank you everyone for the advice, I got it cleaned out last night. Wow what a mess I thought the carb cleaner would thin it down to the point of being runny, and the goo would drain out. I was wrong, it did free it up off of the parts and get it in the bottom of the housing. Then I could...