Recent content by steve tansy

THANKS, Martin, sorry for the mix up on my end your right .125 less than from .179 is .1054 4 inch stroke right on.Thanks again you have help me veary much .Steve

yes, that is what ron said to do i understand this i my problem right know i have not disassembled my engine i was hoping someone out there could please measure a 239 piston for me from middle of pin to top edge to the top edge of piston or crown thanks. steve

thanks, i thought that it could be done on engine likes the engine is not tore down, do you have a measurement from a 239 stock piston that you could give me from the center of wrist pin the top edge of piston, by the way the the new 3 3/8 pistons are three ring pistons tell me and tell me if...

i have purchased a set of 3 3/8 pistons the seller says their fore inch stroke they check out 3 3/8,but not sure if they are for my 4 inch crank can you please help my engine has not been tore down yet, is thear any way to measure the pin location to see if they are correct for 4 inch crank...

rog, will take it will send money order to you send info on total cost to steve . v8fhtoys@tipton.com will forward information on shipping Steve Tansy