Recent content by sprint29

I'm looking for a set of headlight reflectors for a 36 pickup. trying to go back original 6 volt stuff. Thanks

I tried to get a picture posted. couldn't get it to ever show up

Good afternoon, I have a 36 pickup and I'm looking for a place to get the little button clips that holds the upholstery to the cab framework. I've got a few, but not enough to fasten everything properly. Thanks Mark

Good evening!! I was wanting to know the size of bolts or screws that hold down the little inspection hole plate. I'm trying to be original. Thanks everyone !

Then is it painted again after the metal pan is placed on top of the wood and riveted to the sides? I'm sure I'll skin everything up getting the top pan in place.

I'm trying to go back as original as possible. How much of the pickup bed was together before it was painted? I still have to put the wood down and then the metal pan on top of that. Was wondering how Henry did it. Thanks Mark

Thanks Karl, I'll give you a shout. Saw a couple of things that I could use. Mark

Good afternoon, I have a question about the rear fender bolts on a 36 pickup. The original ones resemble a 5/16 carriage bolt, except that the head is the size of an 1/2 inch diameter carriage bolt. And there isn't the little square area below the head. Also, how are they held in? Without...

I'm not sure on the sizes yet. I'm getting one of the rivet kits from Mack Hills. So, whatever they send me. Don't know if they are hot or cold rivets either.

Good morning I was hoping to learn a little bit about installing rivets. The best way, tricks, etc. Getting the tools I might need and so forth. Thanks Mark P.S. I'm putting the pickup bed back together on a 36.

I'm looking for a pair of the "Y" shaped hold down bolts. I have the top hold down frame, just need the bolts. Thanks Mark

Ok, I think I got it. No telling where this motor came from . It was in the glove box and someone put in an electric one. I think I'll do some searching for a correct one. Thanks everyone who chimed in. I learn something new here everyday. Mark

Yeah, That's what I'm figuring out. The visor cover has 3 hole in it. 2 on the right side and 1 in about the middle. The one in the middle is the only one that will work with what I have.

The arm that sticks into the cab is on the opposite side than what the picture shows. That's what has me bumfuzzled.

I was trying to install a wiper motor that I have into my 36 pickup and was not having any luck aligning the control arm with the holes in the cover plate. After some time of wondering what I'm doing wrong I finally realized that my on/off arm is on the opposite side of all the pictures I was...