Recent content by speedy1544

To all, thank you. I did make a tool to dig out the excess rubber in that very small channel in the larger channel where the seal goes. After grinding a screwdriver tip to fit and act like a razor scraper, that was a start. Grinding a 90 degree pick to fit and dig out the small channel inside...

Thanks for the info, and I had to cut out the old gasket and probably I will have to make a tool, and or wire brush the groove a lot more with Dremel, as it is a tight fit for sure. Sounds like you fellas confirmed what I thought. I appreciate the info. Frank

Just asking, as this subject is probably here already. Is there a simple, or best way to install that rubber gasket around the windshield frame on a 34 , stock height frame? I have done some glass work over the years, but this will be a challenge. Thank you Frank Spadaro

32 Phil , thanks for posting a nice and correct reply to this question. It was a long and tedious ordeal , meeting many, many, nice people along the way to the sad end. Dicks assets after all was done passed to his 96 year old Mom. Frank

Parking will be limited , plan on walking from the car. Thanks

Dick Spadaros Early Ford Garage Sale , NOS , parts, hot rod, repro's toold office supplies tools SATRUDAY APRIL 11,2015 6599 Rt 158 Altamont,NY 12009 CASH ONLY 9am - 3pm Info on parts - Mark - 518-300-5826 Info on tools -Frank 518- 423-2405 No Phone Sales Over flow people will have...

We are having a garage sale of all of what is left of Dicks parts , repro's, NOS, tool , equipment, office supplies , shipping materials and tools. SATURDAY APRIL 11, 2015 at the store - 6599 Rt 158 , Altamont NY 12009. 9AM - 3PM CASH ONLY All sales final. If we have over flow customers...

I have a Harman & Collins inc. N.O.S. Rotor , number 1400-1 . I do not know if its for a Mag or Distributor . I think it is for a Distributor , it was found in a desk drawer makers Save , NOS Ford. Any interest or advice would be appreciated. Thanks Frank