Recent content by sojoanfr

I am pushing the rod in line to the crankshaft.

I have checked valves, valve guides, distributor. Seems al to be ok. So I removed oilpan and found at no.2 much sideplay. When pushing rod no2 there is a metallic noise. The other rods seem to be ok. What can I do? Change rod bearing? Change co Is there a possibility to reduce sideplay?

does someone knew, where this noise "tick,tick,tick" comes from? https://youtu.be/OL6artNkrQA

Thanks for all informations fuel flow was good, shut off open there was a good flow out of the plastics filter idle mixture is open 1.5 to 2 turns GAV turning: there is no reaction, my impression May be the adjusting needle is blocked? but choke works The next step can be to check...

I checked timing already 5 or 6 times. First piston was in upper position and timing pin was fitting in gear hole. But I will check it again. I'am from Germany/Hessen.

I hope, someone has an idea. After changing the regulator the motor begins to stutter when it gets warm. The electrical system is a 12V system. The regulator was changed because the regulation of voltage didn't still work. I checked timing, distributor, checked and cleaned all gaps/contacts. I...