Recent content by sjaakslinger

Long time here, so though I'd post an update. Rebuilt LB engine is coming along! Getting close to first startup. Verstuurd vanaf mijn SM-S931B met Tapatalk

Anyone have pictures of the trunk lid seal on a Sedan? We tried to install a new one, but are not sure if we installed correctly. Should the lip of the seal sit behind the trunk lid, or between lid and body? Although the latter doesn't make much sense I guess... Thx. Dennis Verstuurd vanaf...

Ah, to be clear: Steering wheel is left, we drive on the right side of the road.�� About horse transport: they're usually transported in Cargo planes and accompanied by 1 or 2 persons that take care for them during the flight. They're in accessable boxes on the main deck. I used...

👍 Left side driver. Dennis

Thanks. On our '36 the driver's side was actually worse.

We hoped it was a '36, but it's not. I did some googling, but can't seem to figure out what year it is. Anyone an idea? Dennis

Thanks everyone. The car didn't have a radio, no idea if it had at some point or if it was taken out.

Working on a '36. We installed a new fuel tank and saw that the original fuel sending unit had a condenser. We can't find any info In the geeen bible or whatsoever if that was stock. Any info here? Thanks. Dennis

https://youtu.be/JiRN6M3mOvY?si=W6IcXHRnwsoKXvQ4 Might be a bit hard to see, but at some positions the needle can be seen unsteady. Verstuurd vanaf mijn SM-S931B met Tapatalk

Thanks everyone. I did open up the sending unit. Took the mechanism out and sanded the points. I hooked it up to the original gauge and the indications were off. I adjusted it with the toothed wheel in the sending unit and in general the indications are ok now. Only thing is the slight...

Is there anyone here who is running the original heating coil type fuel sending unit and gauge? Just wanted to know if it's normal for the needle to wobble a bit around it's position... Dennis Verstuurd vanaf mijn SM-S931B met Tapatalk

I found this thread while testing an original '40 sending unit and gauge. I opened up the sending unit, took the mechanism out and cleaned the points. I read about the principle behind it, still can't quite understand it, but seems I got the unit going. Also adjusted it by the small toothed...

Thank again everyone for all the info and pictures![emoji847] Great help. Verstuurd vanaf mijn SM-S931B met Tapatalk

Thanks a lot guys...great info! We're gonna give it a try. Yeah, finding a NOS bearing was like finding a treasure.[emoji51] Dennis Verstuurd vanaf mijn SM-S931B met Tapatalk

Thanks. Yeah, we were thinking the same. Making some tool with a large thread and washers and stuff. I suppose the bearing would just stay in place after getting it there... Verstuurd vanaf mijn SM-S931B met Tapatalk