Recent content by silvertop

Just drop the radius rod, much easier.

Old Guy Rich; Your HVLP gun requires a much larger volume of air than a conventional gun. If you are using a 1/4" or 3/8" hose with 1/4" quick couplers you are not getting the volume of air that is required for efficient use of your hvlp gun. I would suggest turning your separator regulator up...

jakno, This may help. http://paintref.com/cgi-bin/colorcodedisplay.cgi?year=1935&manuf=Ford

Bill, Binks Customer Service # 1-800-992-4657

NO Normal use and body oils will remove it quickly.

http://www.caswellplating.com/buffman.htm Lots of information on the above site, along with the needed supplies.

Here is what it does.

You could try www.bobsgaspumps.com

That switch was one of the early units for aftermarket turn signal installation on vehicles not equiped with turn signals. That unit will require the use of add-on lights both front and back. Run a inline fuse from the ammeter to a two prong flasher and the yellow wire from the unit to the...

For Sale---Mohawk USL-6000 Scissor Lift. Low cycle times, excellent condition, 120V. Aluminum ramps required for lift included. $2500.00. See Mohawk's website for details. Sells new for near $6000.00 (SOLD)

The short shoe goes to the rear of the wheel cylinder and connects to the hand brake operating lever.

Brent, I have the instructions from pump #A-8502-A/B sold by Snyder's. The reason given for the grinding of the impellers is : "Repo radiators are more efficient because they have smaller diameter tubes to disperse the heat. Consequently they can not handle the same flow rate as...

This would have the guys at Carnegie Mellon & MIT scratching their heads.

The blue plastic tape works very well for two tone painting. I use 3M tape, but this looks to be similar. I use 1/8",1/4",& 1/2" when two toning, on long runs the 1/2" works very well in getting a very straight line and the other sizes on the curves and corners. It does leave a very crisp line...

x-2 Good advice.