Recent content by Shorty

I have a 35 sedan with a factory replacement engine. The engine is a 37 short block with water pump block off plates on the front of the block. I use the '35 221 iron heads with the stock water pumps. I'm also using a cooling fan in the stock location mounted on an alternator. It also uses the...

I did all wwekend and this morning. My ad blocker is on and functioning..... I hope.

X2 on NAPA

Go directly to pertronixbrands.com then to customer support. They should be able to answer your questions.

Check with Third Gen Automotive Part No B-3740-KT

The key is to start with a clean cooling system including the engine. If nothing else, run distilled water with your choice of cooling system additive. For many years I have used Prestone in my Model A and my daily driver. The antifreeze contains antirust and lubricant. Prestone also makes just...

Why not?

To make a long story short, I had an off topic drive shaft straightened by on older gentleman that had been in the drive shaft business for over thirty years. I watched him as he applied heat to the drive shaft and you could actually see the metal move into the correct position. The metal never...

Thanks Tom, that thread helps a lot. Mitch there are brackets that tie the top wood to the header on 30-31 fords. I have inquired with the various vendors and they state there is no such bracket for the 28-29 Tudor and that's my delima! I have a 28 Tudor built in December of 27 out of the...

Mitch those pictures are fantastic! I too have a 1928 Tudor. Not to high jack this thread but do you by chance have pictures of the top right and top left where the top wood meets the front header panel? I've see pictures of 30-31Model A's but no 28-29 Tudors. If you or anyone else have pictures...

1936-1939 Wide 5 Hub/Drums I have 2 front hub/drums and 3 rear hub/drums for sale. One rear drum measures at 12.040 all the rest are at 12.060. There are minor chips on two rear drums and one front drum that do not affect the braking surface. Pictures available upon request PM me for any...

Here ya go a video of my 1957 Simca V8 60 mounted in my 28 Model A Tudor... Enjoy http://www.youtube.com/watch?v=74gOXQxVBMk (Copy and paste if the link doesn't work) Its a sweet little engine in 1957 it had 75 HP came with a 3 speed syncro'd in 2nd and 3rd gear.

My Dec 1928 Radiator measures 25 inches.

still more. This is all I have PM me if you want more. George

and more