Recent content by seabeecmc

Appreciate the input. Will advise the outcome on this issue. Ron

My '32 Ford has a complete 1940 Ford brake system. New master cylinder, new wheel cylinders, drums turned, new shoes ground on Ammco Safearc to match drums. Brakes were adjusted. Bleeding was done with pressure bleeding system. Brake pedal felt soft and kind of spongy. A friend suggested...

I need a good 3:78 six spline Ford banjo ring and pinion. Ron

Bump

In search of a pair of reproduction or good original 1940 Ford headlight buckets. Ron

I need a pair of Pure Hot Rods banjo rear shock mounts. Ron

Found one

Much quicker than prepping a replacement backing plate and then installing it. No need to break open the hydraulic system either. Regards, Ron

Repair adjuster bolts are available from me. Regards, Ron Hofaker

Just so everyone knows repair studs have been available for years. Dick Spadaro marketed ours up until his passing. You can still get them from me. Regards, Ron Hofaker

Appreciate the assistance. Seller made contact through Ford Barn and advised application specifics. Regards, Ron

Sure wish it had a tag, would make things easier. Regards, Ron

Purchased a Mallory Model A electronic distributor at a recent swap meet. Later realized I hadn't asked if it's 6 or 12 volt. Can someone advise me how to learn the correct voltage short of trying it? Regards, Ron

Ford banjo lenses. You know what to do with them. $30 each. $9 shipping for any number of lenses. Ron 518 756-8415

Wanted genuine original 30-31 FORD roadster lower door hinges. seabeecmc@aol.com (518) 756-8415 Ron