Recent content by ScottNW/Ohio

Re: Ok for a quick trip? - NEED INPUT I honestly think they are SUPPOSED to leak - I've never been able to make mine stop

I sold fasteners for years - there are no "quality" lock washers, only broken washers. If you notice, lock washers were only used on parts that would be removed/replaced often. Lock washers can let moisture under the head, and into the threads, and you have to remember fastener technology has...

I'm attempting to piece together a '28 Tudor "basket case" Could somebody give me actual door opening measurements? Doors are pretty sad as well as the bottom 3"-4" of the body Thanks in advance

Second me for me as well It's a lot easier to assemble on the floor and install as a unit. (and a lot less finger pinching)

Sounds like a ground problem - fresh paint on the headlight bar or fenders? Try a temporary ground wire from a headlight mounting stud down to the frame, and see if anything changes. I had to add a ground wire from the horn mount to the frame to get my headlights and horn to behave. (and mine...

Steve I love the things you come up with - and I'm jealous that you have the 'time' or 'ambition' to dig into these things. I learn something from EVERY post you make. It's a shame that we have a few small minded haters out there

I have a jack from a '92 Ford F150 (a small gear drive jack) and cut down the standard fold up crank - it fits in my 'tool box' in the back of the pick-up. An A is not nearly as heavy as a modern truck, so this raises it up pretty easily

Well, that just changed my plan - I was blaming my "lean" on a weak front spring Mine was also disassembled,(front and rear) sandblasted, painted, new bushings, new shackles, shocks - I've already tried loosening and re-clamping the u-bolts (front and rear), It leans to the driver's side about...

Tom, There is a special bushing made for these (it looks like a standard size probe) the bushing will usually be 3/8 or 1/2npt with a seat inside for the probe to seal on. Any (helpful) auto parts store should be able to fix you up - worse case, you may have to buy a "cheap" manual temp gauge...

I just noticed that I have a 'very soft' lower hose (red line) - I just thought maybe it was caused from my oil cap breather blow-by. I think I will need to investigate further after your photos

I must have got lucky then, I got mine from Gaslight Auto - but I drove 1-1/2 hr each way 'cause I don't trust UPS with something like that Fit great

Somebody needed that case in a way, and you can bet somebody spent a lot of time welding that thing up

Would be a better job than rear window installer on C/C pickups in '30-'31 That was one thing that was definately 'over engineered'

I have 2 for mine, but one is in need of paint (must have been the front one in it's previous life) Ohio only requires one, and you have to keep the state issued (modern) classic plate with the vehicle in case you have to produce it (both are listed on the registration) so I put the modern...

I've got a '31 Ohio plate on the front of my '31 - registered to the truck Not a bad deal here - doesn't expire until 2050 and was only $35 including the Ohio "antique" plate ! One of the few bargains left in this state - until they figure that out too !