Recent content by rvye@roadrunner.com

Will a model a head fit on a model B engine

Will a model a head fit on a model B engine

thank you good post

:):)

We did the same thing on the 650 Yamaha snow pro sled that we raced years ago

You look at the picture close the balance weight has two marks on the crank into marks on the weight and they don’t line up I wonder if that’s the amount that it has moved

Balance weights moving is it possible for the balance weights on a 32 engine that a full circle weights to move in cause a slight vibration

I have a model B engine with for full circle weights on the crank but it still has a small vibration I wonder if they can move

I have a model B engine which full circle balance weights have been added but I think one of them could have moved I have a slight vibration

My model B motor has full circle weights added on but I still get a small vibration it mid throttle

I installed t5 from a 1987S 10 Chevy 2 Wheel Dr. and it’s the best thing I ever did for that car it works perfectly

The best way I found to increase the power in a model a is to install a well balanced and blueprinted model B engine

The purpose of a ballast resistor is that when the points open and close faster on a 12 V car voltage will rise and as you slow down and go along and then idle you’ll get down to around 6 to 9 volts

file:///C:/Users/dick/Pictures/ford.pdf

The thermostat acts as a restrictor the water pump is pushing water too fast to the top of the radiator and it’s going out the overflow