Recent content by ron103140

I have a pickup 1930 that I need brake shoes for if you still have them. My address is, Ron Johnson, 3714 Hayneville Ridge Road, Mathews, AL 36052

I am running a B carb with a B intake that stalls at every stop. Carb was rebuilt by a very good rebuilder. No exhaust or vacuum leaks. High 5.5 compression head. What else can be done to correct the stalling? Ron

i got a flash - all 999 turn signal with other parts and need to know how it wires up. This is the 4 wire unit and not the 7 wire. the wires are, red, black, yellow, and green. a wiring diagram would be a great help. Thanks, Ron

You can disconnect radiator hose at the top. Unhook the 2 radiator support rods. Leave radiator shell on and pull forward and clamp to headlight bar to give room to pull head with water pump on. I just did this and it worked fine but you still need to be careful not to damage rthe radiator. Ron

I am building a luggage trunk for my 30 roadster and need to know where to purchase all the hardware like locks, leather straps, handles and leather corners, and buckles.Please email ron36109@aol.com. Thanks in advance, Ron Johnson

Thanks Ray for the contact number. Ron

Can someone please give me John Hollands contact? I have some that he rebuilt that are leaking also. Thanks, Ron

I have restored my 30 roadster but did not check the frame out for possable bend. In trying to fit the hood it is forward of the firewall bottom about 1 1/2" on the passenger side. Not as bad on the driver side. I had to put 6 rubber shims under the very front body bolt for hood to be ok, now...

Try Tower Hobbies

Gary, there's a good one in Newnan,GA. Robert Carden, Cardens Machine. Phone 770-251-9174 cell 678-613-0516. Address is 170 Smith Road, Newnam, GA. 30263 I am in a large model a club in Montgomery and a lot of our mambers use Carden. My email is ron36109@aol.com. If you need further help. Ron

Walt, I may have one original in my stuff. I will look this morning and get back to you if you still need it. My email is ron36109@aol.com. Ron

Loosen the 2 screws on the striker plate. Tap the striker plate in toward the seat and re tighten screws. Ron

I need an answer to this also. My seat back has the hold down brackets at the bottom but none at the top. I also do not see where they can be attached at the top. Any photos on this would be appreciated. Ron

I seem to have a bent frame also and want to know if any of the ideas to correct it can be done with the body on or does it need to come off. Ron

I think I have the same problem. Hood will not line up at bottom on my 30 roadster. I have put 5 shims under the body very front and still have not gotten the gap out at bottom of hood. Doors due to this I think have been a real chore to align and still not right. They are too close at the top...