Recent content by Robert Christensen

I am finishing the restoration of my 46 Woodie wagon. The reproduction dash plastic is missing the mesh screen on the inside of the radio speaker grill. Does anyone happen to have a decent used screen so I can finish the installation of my grill trim? Any help would be appreciated. Robert

I have a 1946 Ford Woodie Wagon that I am restoring. I am in need of a clean and unrotted used driver's side "B"-pillar. Does anyone have one they can sell? I appreciate any help.

I am looking for a pair of 41 Ford convertible trunk lift arm assemblies for this restoration. I have a pair that are worn and need quite a bit of work. These arms were used on convertibles from 1941-48. Would anyone happen to have an nos pair of these or a very good set? Please let me hear from...

I am looking for a pair of 41 convertible trunk lift arm assemblies for this restoration. I have a pair that are worn and need quite a bit of work. These arms were used on convertibles from 1941-48. Would anyone happen to have an nos pair of these or a very good set? Please let me hear from...

Good morning. I am trying to find the last parts for an engine build for my 41 Ford convertible restoration. I am trying to find the right-side cylinder head, 81A-6049-A, with two ports for the heater valve and heat sensor. Does anyone have just the right side head or the pair if you need to...

Thanks.

Thank you.

I just bought a non-running 1941 Ford in South Carolina this week and am looking for help in transporting it to Colorado. Does anyone know of an honest and reasonable outfit or individual who could transport this vehicle in an enclosed trailer? I am not under any time crunch and neither is the...

I saw a friend using a reproduction of a KR Wilson engine lift tool that is used with the intake manifold removed from a flathead engine. It was so quick and easy to use. It is a small metal piece with a couple of "buttons" that fit into the holes where the intake manifold bolts would go. Does...

I saw a friend using a reproduction of a KR Wilson engine lift tool that is used with the intake manifold removed from a flathead engine. It was so quick and easy to use. It is a small metal piece with a couple of "buttons" that fit into the holes where the intake manifold bolts would go...

Does anyone have a pressure test kit so I can test my 53 Merc block for cracks/leaks before I rebuild it? I am willing to rent or buy one. 970-319-5955 Thanks.

Does anyone have a pressure test kit so I can test my 53 Merc block for cracks/leaks before I rebuild it? I am willing to rent or buy one. 970-319-5955 Thanks.

Does anyone have the center chrome plated piece for a 1940/41 1/2 ton pickup truck that they can sell to me? I have all the rest of the parts to put an original grill together for my truck. 970-319-5955 or message me here. Robert Robert Christensen is online now Report Post

Does anyone have the center chrome plated piece for a 1940/41 1/2 ton pickup truck that they can sell to me? I have all the rest of the parts to put an original grill together for my truck. 970-319-5955 or message me here. Robert

Does anyone have a pressure test kit so I can test my 53 Merc block for cracks/leaks before I rebuild it? I am willing to rent or buy one. 970-319-5955 Thanks.