Recent content by rlsmith337

I got a nice 37 frame with motor and trans radiator and steering. Motor is supposed to be good, but I have not heard it run. I want $2500. for it and I will deliver for that price. Richard Fitzgerald, Ga. 229-237-3255 cell or 229-468-3107 home.

I have a 31 Vicky on a TCI chassis independent front end, 9" ford posi rear end, SBC engine , 700r4 trans. Lots of new parts. NJ title. $25,000. Richard 229-237-3255 cell, 229-468-3107 home

No Racing anymore at this time,per the new owners.

I have a 31 Vicky rear seat $300.00 plus the ride. Richard 229-237-3255 or 229-468-3107

JW Lawson did a lot of dino work on flathead cams his results are in his book,simple answer is yes stock cam is better for low and mid range torque.

I have one, but it will need to be recromed

Quick on promisses short on delievery, be prepared to wait a long time to get your part, quality is good, price is good, wait is bad. Pay with credit card so you have some recourse if it goes bad, stop payment it will get his attention.

Babbit is the metal that is poured on the rods and mains to make the bearing surface.

ebuy

got after market one 229-468-3107 Richard

Go to NAPA Store they still have books, find the oldest old man there, he will know how to use them. A lot of old car suppliers get thier parts from NAPA and mark them up a lot.

Frames are the same, except bolt holes for mounting bodies and front fenders are different

JWL Fitzgerald, Ga.

Building flathead ford for 1934 ford and was wondering if ospho would prevent corrosion in water chambers in block.

Ol Ron and Speedy Bill said copper so that is what I will use on mine.