Recent content by richie rich

looking for cam drive for atwater kent model h distributor

need 4 main roller bearing ball cap

wont crash my tin the garage bs my driveway is up hill i pulled in have give half throttle to get in garage my foot on the low pedal and i make it into garage i let out the low pedal and the car lunge forward should have been neutral if you let the pedal all the way out and i did not take it...

looking for atwater kent distributor model H cam drive gear beveled gear looks like a pinion gear

found one thanks model t ford barn

You may have arcing in the coil box that is intermittent look for black burn spots inside the box from moisture if that,s the problem replace with a plastic coil box i had a miss and could not find ran it in the dark garage did not see any thing so i took coil box out and bench tested it and had...

i have a pin on clutch plate that is stuck down and the clutch finger has a lot of play can i take out the clutch housing bolts to the brake drum so see the damage i do not have the time to pull the engine out and the rear end right now

wanted 40 tooth recessed ring gear 13 pinnion gear

yeah week clutch spring i thought about that a parts suppler sells a part that goes between the spring looks like a quick fix till next year when i tear down and inspect there are a few things i want to do

My 23 dose the same thing its really bad the hole front end shakes bad double clutch back off the throttle then it bogs and slowly picks up speed top out about 50 on my phone app not good emr brake high speed backs off about 5 clicks have to hold with foot will replace ratchet and paul today...

yeah most of time hood would fall over on fender replaced with model a hood retainer 2 screws and its off hood dose not come off i can put both side up i use 2 wooden blocks to hood hood looks mickey bot its its stable but with the model a hood prop it has 3 hood rods i think i might have to...

At the Car show last week "won second place" first time out ! The Model A next to me had hood prop that alllows both sides of the hood to be open to work on and display the engine can i put this set up on my 23 touring .