Recent content by Rem/Mo

I didn't think a tudor had a rear floor board. Only a front and center.

The driver I have is just a pipe nipple that fits the i.d. of the seal with a washer of the right size to fit over the nipple and o.d. to match the seal welded to the nipple. Screw a piece of pipe the proper length in it and it works great.

Great thread and thanks for the pics. I have one of those that I have beem trying to soak free to get the head to turn. I had no idea that there was a base for them. Looked like it would have to be fastened to the floor to be stable. It is good to see all the attachments that were available. I...

Thanks for that info. I have a very good set of T doors for my 82A but have not looked them over closely. I was under the impression that they were the same. I'm sure thay will be close enough to be ok but it is good to know to watch for some minor differences.

Kind of makes a difference if I'm starting out headed up hill, down hill or on the level. Same with down shifting. Down shifting coming to a stop or slow down or down shifting on a pull.

On someones advice I purchased some Geocel 3300 Polyurethane roofing sealant. I haven't used it yet but it looks like it will be good for the job.

I have not used it but do plan to. I have read quite a bit on it and it seems to be an equivelant to POR15.

Have you ever looked at KBS Rustseal. http://www.rustymetalpaint.com/Stop-Rust-Coatings_c_11.html

I think 19 gauge is what it is. 20 ga should be ok. Maybe what you got isn't 20 ga. 20 ga should be about .036 thick.

I wonder if those might be the measurements for the cab only. 51" seems about right for the cab height.

Here is a pic of a reproduction latch in a brookville door. It was a little tricky to get it in place but with a little trial and error it slipped in ok and fits and works nicely. The top slips up inside the door panel.

I suppose most could be fitted to it but the 29 AA never came out with them. Only a manual wiper.

#384

Is there a number stamped on a pad on the left side of the block just below the head gasket.

I have a used one laying on the floor that I think is a '46. It measures 43 1/2/