Recent content by RAYSSUPERDELUX

I need a RH upper door moulding for a '48 Ford convert.- Thanks Ford Barn

Thanks Ggmac- I'll have this in in no time- R Sullivan

Hi gents- I'm installing a new trunk light extension wire in my '48 Ford convert. Where should this wire enter the trunk? I have replaced the floor pan. Thanks, R Sullivan

Is my new headlight cross over wire routed behind or in front of the radiator? Thanks for the help. This is a '48 Ford-

I am installing the headlight crossover wire on my '48 Ford. Does this go in front of the radiator? Thanks for the help.

Kube- thanks for the info, as soon as I read I remembered how the fenders came off.

Hi gents- how are the nuts, bolts, and washers installed on my "48 ford rear fender? Is the flat washer and bolt pushed up from the wheel well?

Hi gents- how are the bolts and washers installed on my '48 ford rear fenders?

Ford 8ba engine-turns, always stored indoors, ran when stored.

Ford frame-'42-'48 good condition, surface rust- no pitting

Hi gents- I've misplaced the two firewall clips on my '48 ford for my choke and throttle cables- can anyone help? Thanks, R Sullivan

Hi gents- The stainless trim on my '48 Ford dash appears to have glued on fasteners- has anyone replaced these? Would JB weld be a good bet? Thanks, R Sullivan

I need a body mount as shown-the left and right mounts are different- (mirror image)

Hi gents- Does anyone have a website for ordering dash woodgraining components? Thanks for the help.

Hi gents- I'm having trouble installing new parking brake cables on my '48 ford. The rear cable (loop) will not pull forward enough to fasten to the front cable. Any ideas?