Recent content by Ray

I know this is newer truck, but I'm looking for a pass side exhaust manifold for a 1986 F150 302 engine. Obviously no cracks or damaged studs. Let me know price and shipping to Palmdale, CA 93591 Mods if this is too new sorry and please delete.

Pretty sure its in the gas tank, part of the fuel sender assembly. So you either have to pull the tank, or maybe theres an access panel under the seat/ carpet/ trunk mat directly above the unit. Not sure if Ford still does it, but they used to have impact fuel cutoff switches in the...

I have a disc brake 9 inch rear out of a Versailles for sale, its complete, needs all brakes gone through. Has surface rust all over it. 2.79 gears, 58 inches outside width. Located in Palmdale, CA 93591, $550 obo cash on pickup, or YOU arrange shipping. PM me or email me at...

http://www.fordbarn.com/forum/showthread.php?p=103225#post103225

Parts for sale...

I will seperate the pump, brackets and crank pulley for $250 shipped in US, or $400 + shipping for everything

I have for sale a complete power steering setup from a 57 Ford Ranchero. It is all used and will require rebuilding. You get the stuff under the car, as well as the crank pulley, correct power steering pump and brackets.I'll toss in a power steering horn ring for 57 and 58 too. Shipping is...

I have decided to part out these 59 Fords I have, I cant seem to sell them whole. I have a Galaxie 500 2dr HT, Custom 300 2dr post, wagon. The wagon has been majorly parted already. Please PM me here or email onemansjunk1@yahoo.com for requests. Doors $75 up, Hoods 125 up, Rear ends $400, many...

Thanks Raceron! Thats what I needed to know. :)

Can anyone answer my question?? I see ones like the one I have listed on ebay, and they say they fit all 272 292 312. Is this true?

Its really tough..most FE engines look pretty much the same. A 360 was used in trucks. 390 too. Best to check the stroke with a wire or similar so you can measure.

Just because one guy finds one cheap doesnt mean they are all cheap. He got lucky..thats all. $3,000 might be a tad much, but if its all there, and not terribly rusted, its worth every bit of 1500-2500.. all depends on condition and OPTIONS. Not sure what "rust in the usual places" means.. I...

I have a friend looking for a crank pulley for a 57 Tbird 312, I have one from a 57 Ranchero 292. Is it the same? He doesnt have one to compare it to mine. Thanks..

Nobody building these?

Bringing this back up. Will take some trades.