Recent content by pinball73

when i do get out i enjoy driving it around & watching people & the look on there faces! kids today can hardly believe that it is a car! they have never seen anything like it! i usually tell them when it was made it was comparable to a Cadillac in today's world. as far as having kids, grand kids...

where would i find Bat? i am not familiar with that name!

As for the way it runs, drives & starts, it will not turn over twice & it is running, and it should be that was! i have rebuilt every thing on the car that needed it . as far as driving & stopping i don't think it could be any better! of corse i could be a little predigest

North central! Kirksville Mo area.

North central ! Kirksville area

I have sort of lost interest in my in my little 29! looking for some ideas where to sell it & what it is worth if i decide too! it has been fully restored back it it's original glory! it is 95 to 97 Percent original! made a fey upgrades to make it ride & handle better! It is a pretty old car...

thanks! i drilled the one out on the pitman arm & welded it back no problem, so i may try to do this.

all the shims i used had a hole drilled in them so they would slide down over the bolt! no way they could come out

well i put one in when i rebuilt my 29 engine & i am very pleased with it! when i did it i also replied the front pulley, where the seal makes contact, as mine was worn. have not had a problem with it! no leaks, no drips, no runs

Well i have not been on hear for a while & as usual i have a question! to start with i finally found a two tooth steering box/sector & have it rebuilt & just about ready to install it on my 29 & by the way i see why every one wants to use them! they can be adjusted down so fine that there is no...

that is a good idea! I am not ready for paint yet! I am still doing a dry run on the bench

well it sounds like I am on the right rack! just not there yet! thanks guys for the information. I am still playing with it & it seems to me it is going to be better than my seven tooth ever thought about being

Ok, a few months ago I had a post on hear about having a problem with getting the free play/slack out of my seven tooth steering sector/box! I was advised to remedy the problem too install a two tooth box. well I have acquired one & gone thru it completely & I am in the process of dry fitting...

ok! the steering box! the picture you show is the cross shaft that the pitman arm attaches too. I am talking about the shaft that the steering wheel goes on! she slack I am speaking of is possibly between this shaft & the worm gear on the lower end.

got a question! what is the possibility of having slack between the worm gear & the steering shaft on my seven tooth sector? that may be the one thing I did not check! I really can't remember? I will find out because the sector is coming out again! I am getting pretty good at removing it. the...