Recent content by phil pavicich

Thanks to Deuce lover he sorted my problem out with early ford store , my missing parts are on there way thanks again Sheldon cheers Phil

Im having problems with Early Ford Store ,not sending parts that ive paid for, twice now on 2 separate orders ive paid for the item the"ve billed me for the item but not sent the items , no messages to say there on back order , no reply to emails , dont answer the phone , might have to use...

$50 is only a carton of beer down here

Yes its definitely a 40 hub , the sleeve 68-1236A 3.120" OD is for a 34 hub ,this sleeve presses into a 34 hub and then you use the 68-1225A roller bearing , this sleeve is to big in diameter to go inside my 40 hub which measures 2.840" OD , yes this bearing runs directly on the hub...

I Have just pulled down some old stock 40 rear hubs and the outer dia of the hub has lots of pitting ,(water /rust damage from sitting a long time ) is this a sleeve inside there or is it original machined hub surface , Is there a sleeve available to press in and fit smaller od bearings ? or...

I am having a problem with my adjustable lifters on my 8BA i have installed Bob Drake adjustable lifters these came in a Bob Drake box , after only approx 150 miles, one of them has loosened off to the extent i can turn screw the bolt down with my fingers . I have rung my supplier and...

Karl the photo you posted shows the spring on the outside of the folded handle mount , i have this type on my other 34 's , the one i have is , the spring is inside the folded cage section and the handle comes thru the middle of the spring as shown in photo, it does not have the spring on the...

I have a broken hood latch spring on my lhf hood handle , i have purchased a new spring from midwest springs , and am baffled as how it goes together , The spring needs to be tentioned on the shaft somehow, is there a special way to do it . The end of the handle has a D shaped end , but it very...

thank you just what i needed

Yes that was me , i imported a 34 5w from south africa , i had asked the elderly gentleman 80 year old who i bought it of to remove the brake shoes of the car and remove clutch plate , Which he did , but he put them in a cardboard box and left them in the car as he thought i would need them...

I am fitting the truck lid support bracket , which i have to make as i havent got one , i have the slide which is attatched to the lid , i need to know how far does the bracket hang down and how far back is it from the front of the lid , could anyone post a pic please thanks In advance

Years ago i bought a long king pin reamer 12''long from macs they dont list them anymore /discontinued , mine is now gone blunt any body know who sells them .thanks in advance Phil

Still looking for this thrust washer any leads please thankyou in advance

I have fitted a few of the Australian repo grills made by Chris Nihill out of Bendigo Australia , they are really good quality and the fit up is almost perfect , when he makes them they are in raw finish unplated so you can trial fit tem before you plate them , i am very happy with mine