Recent content by pbc

  1. P

    1941 Draglink

    Draglink found thank you Chuck
  2. P

    1941 Draglink

    Looking for a good useable draglink for a 41 ford car.This is a bar with no bends i believe 35-41 are the same thank you
  3. P

    Wiper sweep

    51woodie all 41 -48 fords are the same not sure on early or later
  4. P

    Wiper sweep

    That motor I believe is not ford notice the pivot arm its straight fords were curved. You may not get a correct sweep
  5. P

    Horn Ring

    its good
  6. P

    Horn Ring

    Thank You I need to check my wiring to the relay
  7. P

    Horn Ring

    Hello I have a 41 ford trying to get the horn to work.I converted to 12 volts a while back I had no luck with the trumpets so went with a modern horn.I tested the horn and works I have it wired through a horn relay.I am trying to figure out the wire to horn ring how does it break contact.How...
  8. P

    41 handles

    one set of interior door handles not perfect slight chrome pitting but still shine up complete set asking 25 dollars shipped.Center dash strip which I only have 1 sold the other could use a replate 10 dollars shipped.Exterior door handles both have some dings in them 15 dollars shipped
  9. P

    gen bracket

    Offset gen bracket off 8ba nice shape the band seems a little distorted with a slight bend.And tough pivoting needs oil asking 35 dollars shipped.And a set of thermostat housing cast 15 dollars shipped gen bracket sold pending water housings sold
  10. P

    1941 Tudor Dash Trim

    The full length diecast trim with the clock cut out are they rare? I always see the ones without the clock cutout.Were these aftermarket could have ford made these?
  11. P

    6 to 12 volt horn

    yes duel trumpets I have been working on this car off and on for the last few years.As I have been thinking I had these horns off and painted them.I forgot I did that. I also am leaning towards a ground.I do have the 6 volt relay I was told it still may work? This week end I will try it out...
  12. P

    6 to 12 volt horn

    Thank for the response I will check for voltage at b terminal wont be till weekend. Yes I did check horn button to s terminal and it works with a voltmeter. Correction I went from battery to button and it worked
  13. P

    6 to 12 volt horn

    I need some help from someone who has gone from 6 to 12 volt and changed polarity to neg. I can get my horns to work but not off the three terminal relay.I have insulated the horns that may be a problem. s terminal to horn button h terminal horns b terminal to pos on battery this is a 41...
  14. P

    WTB gauges

    please delete just sold the car
  15. P

    8ba block

    block and parts not for sale
Back
Top