Recent content by Outback

  1. O

    1937-48 Steering box rebuild

    Thankyou, very helpful. Seems the copies of the article are gone...
  2. O

    steering

    That sounds like a likely situation.
  3. O

    1937-48 Steering box rebuild

    Glad I saw this article. Could someone confirm if the 37 box is the same as 48 & if the steering shaft is the same length?
  4. O

    55 Ranchwagon fuel tank question - rhd

    Thanks, I assume rhd vs' lhd should be no different, but there is lots I don't know. The tank i have is ok, but the car has an efi windsor & the pump set up needs attention. Just having a think
  5. O

    55 Ranchwagon fuel tank question - rhd

    I have recently bought a 55 Ranch, is is an NZ delivered factory RHD. I am wondering if the fuel tanks in the wagon's are any different to other body styles? Thanks
  6. O

    Model T Ring gear,

    29 Vin nearly there! No one could accuse you of pushing up your post count! �� in the old days of the HAMB - FNG was your title when first signed up... lots of people posted alot to get rid of it! Haha
  7. O

    Model T Ring gear,

    Good info Rotorwrench, Interesting thought Elmo, would need to get my hands on one to look at.
  8. O

    Model T Ring gear,

    Ok thanks. Austin 7 is another thought i have had in the last couple of days. Pinion needs to be on axle line like early fords. Can't remember the term ��
  9. O

    Model T Ring gear,

    Dan, Nash's are very uncommon over here & most pommy cars have a very low ratio, will keep looking, thanks. I also didn't know that the pinion count changed but ring gear stayed the same, facinating!
  10. O

    Model T Ring gear,

    29Vintage, that's my stomping ground.
  11. O

    Model T Ring gear,

    We certainly would using a matched set of gears, the reason for primarily asking about the ring gear is that is the major problem in terms of diameter. It would be nice to be able to buy an off the shelf set of gears, rather than forking out big dollars for a one off set. The Amilcar is...
  12. O

    Model T Ring gear,

    I had a chance to measure the crown wheel we will be replacing it is 7 1/4" Thankyou for your time folks
  13. O

    Model T Ring gear,

    Dan thankyou so much, that is what we were looking for. Is a 40 tooth ring gear 3.5 (ish ratio?) 29 Vintage, I can't PM as I don't have enough posts yet. Where are you? Rotorwrench mid 3's would be optimal, the car will be running a 90CI HAL
  14. O

    Model T Ring gear,

    Thanks Rotorwrench, In this case the Amilcar has a conventional diff with universals & tail shaft. We looked at an A model center as I had one loose but it is too large in Diameter. I didn't know T's were straight cut. This mix n matching is what gets done here at work. One of the boys is...
  15. O

    Model T Ring gear,

    Thanks guys, we won't be using the whole diff, just the crown wheel/ring gear & pinion. We will use the Amilcar diff housing & axles & machine parts to fit, if it - ring gear - will fit. The alternative is to have a new gear set manufactured. But that = $$$'s
See more
Back
Top