Recent content by olfarmer

Thank you

I think there are four facing front and four facing rear. That would give the camshaft the most amount of oil. None of my books makes it clear. Thanks in advanve

What is the correct position on the squirt holes on the left and right side rods? I have rods with the same numbers from prior rebuilt I guess. Looked thru my books and been unable to find it. Thanks in advance

Working on a 8BA found three of the four plugs you drive in the crankshaft was in the oil pan. I have threaded the holes with 3/8 NPT tap. My question is would you install aluminum or steel Allen headed plugs? The steel plugs weigh about 132 grains and the aluminum plugs weigh 64 grains. Thanks...

Thanks Ron

Are most air fuel meters mount in or under dash? Are there any that are hand held , without welding a connection for sensor

I am looking to buy a air fuel ratio meter to tune my 8BA. It runs good, checked plugs not burning very clean they are black. Looking for recommendations for a good one and ones to stay away from. Thanks in advance

Thanks for posting

I am needed a pair of rear fenders for a 1940 I/2 ton pick up. thanks in advance Mike mrc500@hotmail.com

John, I will take the rolling frame, can you send some pictures of the cross members? pm or email me mrc500@hotmail.com thanks Mike

Hello, I am looking for a 1940 pick up passenger door. PM me or by email mrc500@hotmail.com thanks for your help Mike

I am getting ready to replace the boards in a 40 pick up bed. I have some cypress boards that I was thinking about using. In the past I only have used oak. Has any one tried the cypress boards before or think they would work ok? Thanks for your sugestions and advice Mike

Hope everyone has a safe and happy Easter where ever they may be.

Cecil, Shelly will in our thoughts and prayers for a full recovery.

On making my 40 pickup a better driver it was suggested changing out the four speed for a three speed transmission and changing the rear end gear ratio. In looking the parts I was wondering if it would be better to look for the 42 and up open drive line rear end and a three speed trans that...