Recent content by Ole Lou

  1. O

    32 Ford Front end Alignment

    Believe Dennis Lacey makes an adjustable link to correct the problem. Our friend Charles has that setup on his 32
  2. O

    Red inner tube

    Red rubber inner tubes used to make the best sling shots
  3. O

    32 peddle arm alignment

    Should peddle arm be heated in bending to make inch adjustments . Or can they be bent while in the chassis without heating. Having trouble installing wood toe board and peddle arms are not lining up with slots in the rubber bumper plate or the rubber bumper stops.
  4. O

    Weatherhead 1512 & oil filter

    Thanks JSeery. All of the fittings you listed have the .065 restriction but they all have 1/8 NPT female end. That is the same as the weatherhead 1512 that I have. I was under the assumption(my fault) that the 1512 had an inverted flare in the female end of fitting. Bought a 1/8 NPT male...
  5. O

    Weatherhead 1512 & oil filter

    I can send to an email address but do not know how to send to your reply Sent from my iPhone using Tapatalk
  6. O

    Weatherhead 1512 & oil filter

    Located a Weatherhead 1512 fitting with the small restricter hole to use on my oil filter. What size tubing and fittings are used with the 1512? From the female end of fitting it looks like it requires a Ford fitting(feral & nut), but the line indentation in the fitting looks smaller than the...
  7. O

    32 Vintique Fuel Tank question

    Checked clearance of sending unit post and it is not touching floor. Pick up tube assembly which is a repop and it seems to be touching floor. I do have shims under the last two body mount bolts on each side. 1/8 in front and 3/16 in back When I installed new subrails and floor I used an...
  8. O

    32 Vintique Fuel Tank question

    Has anyone had problems with sending unit in Vintique fuel tank not allowing body to fully rest on frame rails? if so, any suggestions
  9. O

    32 rear window metal channel

    Metal channels found. No longer need
  10. O

    32 rear window metal channel

    I need two of the rear window channels that hold the vertical window runs in a 32 5-window coupe. The picture below is what I need two of, I understand these are approximately 4 inches long and attach to the wood of the rear window structure,
  11. O

    32 5-window rear window questions

    Dave I'm looking for the sheet metal channel like the first picture Terry posted
  12. O

    32 5-window rear window questions

    Thanks Terry and Dave
  13. O

    32 5-window rear window questions

    Does anyone repo the metal channel?
  14. O

    32 5-window rear window questions

    Had the package tray and window mechanism apart for several years for repairs and paint. Does the two wood vertical stanchions have two sheet metal channels that holds the window runs in place? It seems mine did when disassembled but have lost. If there is supposed to be a metal channel for...
  15. O

    1932 crossover harness for right taillight

    On a 32, how is the crossover wiring harness routed for the right hand taillight? Does it run across the front of the gas tank or the rear lip of tank?
See more
Back
Top