Recent content by oldtin1

sold

bump @ $60

gone

Here are a couple of mine.... My 33 as found- as of last summer- and my twenty five year parts collection that resembles a 35 pick up.

Reduced to $75 for all 3 axles.

Reduced to $75 for all 3 axles.

Sold.

Richard, I still have the 4cyl bell from my truck, its quite a bit shorter than the v-8 hogshead that RMR&C showed. Now I'm wondering if the trans input shaft length was longer on the v-8s or was that all taken up by the clutch stack up. The more years I spend messing with these old cars and...

Ok, you fellas figured out my mess. The trans I have is shorter than the trans/hogshead combo that RMR&C posted a picture of above. Do you happen to know the length of the trans/hogshead combo above? This is the trans that I was trying to use. It fit well in the 35 with the 59ab and the...

Thanks for the reply Richard. Unfortunately the big truck trans mount isn't reversable, but I do appreciate the info on the front mounts. I compared pics of the 21 stud water neck/mount and thought I may be able to fab up an adapter from the 59ab pumps to the frame, once I figure out how to...

1. I would have to measure the axles I have on hand (31aa, 33bb, 35bb) to confirm that the torque tube lengths are the same. 2. I know absolutely nothing about the eaton rear. 3. you can get the axle ratio off of the speedo gear housing on your torque tube as long as it is original. All...

I have read several threads here and on the H.A.M.B about the length of the A and B engines being longer than the v-8s, including this post ( http://www.fordbarn.com/forum/showthread.php?t=3123&highlight=1933+bb+truck&showall=1 )that references the rear mount and driveshaft length as the changes...

sale pending

1968 mercury 429 Disassembled, tanked, bored .030, new cam bearings and soft plugs installed. Stock crank unmachined. Stock rods unmachined. Stock c8 heads. Comes with the original c-6 and a stick bell with clutch, plate and flywheel. I paid nearly $300 for machine work will sell all for $300 or...

1 pair of big truck front fenders including front frame brackets, inner panels and two sets of short running boards. Fenders have some dents and some rust perforation in the skirt, headlight stand area, but are usable / repairable. The running boards are worse off than the fenders but could...