Recent content by Oldbluoval

FYI they are called side curtains Doesn’t sound like you’re missing anything. The if old, they may have shrunk enough to not allow fit. Try attaching to the front and pulling the rod to see if it can be inserted into hole in top of door Just some thought

Bert’s bought a lot of Bratton inventory

M&S were not good. Stipe I understand not available. Not sure who is making currently but vendors state USA

Zach Great that a 44 year old is involved! I make a line of specialty parts for Model A. My concern is based on the fact that most that contact me are my age or older…. I’ll be 79 Saturday…..so far, blessed with great health and abilities! Praise the Lord!

It makes me pause when a vendor has no phone number and hasn’t answered from their own post here!!! Go figure …..maybe pre-Hershey has him swamped??

Are the polished ones still in stock? Your website says not.

Help! I have stuff to trade…

No front x member is different

Bob It was pushing $85 shipped

Joe at Tam’s might shed some light on this

Yes stay away from silica…big health hazards. Tractor Supply sand is slag. Wish I had a source as Brent described near me! Would be well worth it to have trustworthy sources.

If possible, I hand strip paint and use heat gun or light propane torch to remove body filler. Then dust with sandblaster for rust and clean off. I just use fine sand from Tractor Supply….not cheap but convenient and dont use all that much.

I’ve “heard thru authoritative sources” that the last family member stepped out. The operation was left to the remaining staff to carry on as they wished. When they no longer “wished” to shut it down…..maybe that is where they are! Steve Becker or Don Snyder would know the truth skinny in them...

Jb Try a 180a! A400 not all that bad as body is rather fixed with the top rails

Karl is an asset to this hobby!