Recent content by nobby

thanks must be all good everywhere

and a pair of front fender inner panels for 36 and grille badge

https://www.youtube.com/watch?v=0XT2L97kKls&t=3285s i have a 37 hood 54.23 minutes on this vid located in the slough in the UK

the senders 12 volt gm style come with the 5 to 6 adaptor then you can run an aftermarket gm fuel gauge the benefit here is the OHMs rating will be the same i.e. you will get a correct reading note IF you buy a poly plastic tank, the central losenge prevents the long length of the rod and float...

oh, there is another real good drivers lhd door shell, real good £600 and a blasted and painted pickup seat upper and lower £300 bare frame and springs stuff is in slough UK ooh i have a pair of real good 38/9 1/2 ton ford running boards ooh and a 35 to 37 set and a spare wheel carrier. oh and...

pair fo front south african 37 cable back plates £50 loaded 37 axle and bone £250 minty 36 axle californian £200 37 screen frame no holes £250 37 screen hinges complete a pair nice £125 37 van rear doors rust free but havy dents £250 37 pickup passenger lhd door with bullet holes but solid £500...

oh always wanted 37-40 rhd spindles in mint condition 39 or 40 right hand drive pedal assemblies rhd clutch cross shaft with stock 37 ish lever and the stock long rivet want 35 36 rear radius rods at the minute and f1 oil pan and pickup rhd headers that go on with stock rhd steering box really...

all this crap is located in slough west of london 5 miles from heathrow airport 1. 37 frame rusty no front crossmember £500 2. 37 frame rusty no front crossmember £50 that one has been repaired badly 3. 40 ford front crossmember rust free but has motor nmount holes modded and has a ding to...

need to get them to new jersey want a cab back and doors don't care 32/34

also want a dash and windsheild

as close to new jersey as possible for shipping to the uk thanks

Hello Sd, pardon my ignorance, but is 'SD' San Diego, and is it close to the west coast shipping place. am I asking too much for you help, with regards grinding the rivet heads and drilling out the hinge screws, in order to make shipping easier. thanks Nobby p.s. what is the other door...

hello may I have picks would you be interested in taking the other door of and the rear panel - curved tops then ssend ing the dust to new jersey?

[I]