Recent content by Newaygo Kid

I have a growl/howl on the left front when applying the brakes any ideas. Thanks

I have had a brake howl/grumble on my 36 left front and am tired of it. Could my problem be the nos shoes that I have. Thanks for the help

Look in macs they list those bushings, I think GM is correct I made my shaft also, good luck

I bought parts for one of those 10 years ago from Green sales. I just seen the parts somewhere a week or two ago if I remember I will post it.

Bruce I am interested I think they may fit a 36 pickup let me know if you still have them thanks Chris

Are you guys saying the older fords with radius rods do not need them I have a 36, thanks

A pair of 37-39 front drums nice shape with bearings and caps. I bought them thinking they would fit my 36

I am looking for a drum for a 1936 the drum itself would be fine or the complete drum and hub for the front would also work, thanks Chris

I bought some front brake drums and hubs, thought they would work. My old drums have the drum s held in place to the hub from the wheel studs and the new one I bought are one piece casting. The new ones have a different bearing depth and will not fit the drum all the way over the shoes. Does any...

I think the briggs are a flathead divided by 8

I have a 1936 ford pickup 52 v8 flattie. I just put a 39 steer box in it with a Drakes steer box mount. The box is not gonna fit thinking about maching 100 thou off the header flange. I also could lift the front of the engine, how much can the engine be lifted without causing driveline problems...

Ron, I have done this a few times and it worked for me. Feed a long chain into the tank a couple of pounds of nails and a couple gallons of parts washer solvent. Put the neck and cap on and throw it into the back of a pickup drive it around wherever you go for a week or so. Then I washed it out...

Thanks for the reply. Petronixs said the ecoil for this conversion does not need the resistor. have you used the ecoil

I also used the headliner from quiet ride. It was a ***** installing and if you use it take your time.

Has any one used the electronic conversion for the mallory dual point. Also thinking of the ecoil that does not need a resistor thanks