Recent content by nemw001

Thank you all for the help - many minds = many outlooks on same issue - sometimes we all develop tunnel vision and need a new perspective - again -Thanks.

Had timing cover off, so lined up timing marks on the cam / crank gears - then pulled #1 and #6 plugs to be sure that valves were closed, precautionary move, the "wider" part of distributor drive facing down and narrower one up - the "slot" was pointing at about at 11 oclock - and -==> inner...

Thanks -

I do not think it should be a problem, but a stupid question asked is better than one not asked that causes heartache and headaches, does it matter if condenser is grounded to the ditributor mounting hole OR to one of the coil mounting screws? The one I got on distributor after over haul was...

Thanks - checked condenser connections - good, clean, and tight.

Update -- took of muffler and no change - took off timing cover and barred engine over to check actual timing mark alignment, they are right on - it has a fiber cam gear and no teeth were missing and I did not see any cracks or suspect markings on it - I am new to this flat head work however, I...

I never took dist apart, I presummed that it was OK - I did notice the intermittent spark that was a result of a bad condenser it appears - so I replaced that but as you know did not have to tamper with the distributor to replace it - When I got it back I bolted it right on and tried to start it...

I did try starting fluid - and still got the popping thru carb - I even tried raw fuel down carb left choke open, and put fuel pedal to floor with the same reults.

Car was starting and running fine - then - started to be hard to start and would start and run BUT then when warm would not start - SO I checked for fuel, air, spark and there was NO spark at all coming out of rotor / distributor - so I sent distributor out to VanPelts for overhaul - got it back...

I am going to take off the timing cover and check for gear alignment or some other issue behind it - will keep all posted.

took off muffler and cranked it - still justthe backfiring.

Thanks George - I will check it - this distributor was just done by VanPelts so I ASSummed it was fine - but ya never know -- where you at in Mid-Coast area? I am in Warren.

Took off muffler and tried to start - same deal - no start and backfiring out of the carburetor - I am going to order caps, inner and outer, and wires. - will update after install them hopefully by weeks end.

I am going to disconnect exhaust at the manifold and try to start it and see what happens. I held my hand over tailpipe to check and see if there was pressure there, and seemed to be ok. However, no backfires out of the tailpipe may indicate some sort of restriction that my calibrated hand cant...

I did verify firing order using VanPelts diagram, I took caps apart and checked them, saw no sign of arcing. I ohm checked the wires with loom and cap attached off car and they were all like 2 or so ohms, I wiggled them to be sure there wasnt a chaffed wire or two grounding out in the metal loom...