Recent content by MrPhat40

Dear Ford Barners. I have a few misc 1940 Ford parts for sale. Deluxe Door Arm Rest with hardware: $50.00 (it is covered in vinyl) Fiberglass chin: $40.00 New Drake door handle (1938): $20.00 Radio conversion plate (from the OEM Ford to a two shaft style) with trim rings: $30.00 Deluxe grill...

Have for sale a very decent O1A-7507 clutch equalizer shaft ball and bracket. Asking $15.00 I think it will fit in a USPS small priority mail box, so shipping would be reasonable.

Looking for a 1938-39 windshield frame. Condition is very important. Will pay for quality. Thank you. MrPhat40

Dear Ford Barner's, My existing door latch screws are getting pretty wallowed. Could any of you direct me to a source for both the door latch ( where it screws to the jam) as well as the screw that holds the door handle in place. I would need the conical washers as well. As always I thank you...

I double checked and compared the left side with a centered socket and the right side with the socket on the outside of the housing. You can definitely see a difference in that the drivers side is very visible and the passenger side it no so noticeable. Going to remove the socket and try to...

Thank you I will keep that in mind. Going to try and drill out the rivets and move the socket over to the middle of the bucket. I booked marked your ebay page.

Thank you for the image. It is what I was thinking. I will need to move the socket in one of my re-pops. A question if I can not make it work would you be interested in selling one of your originals?

Thank you all for your advice. I did use some shiny silver ( almost chrome) duct tape I had left over from an insulation kit. Lined the buckets as best I could. It does work. I think I will try to remove the socket and bend it so that it is more centered in the housing. Looked at it today and it...

Dear FordBarner's Recently I replace the old rusted and generally crummy taillight buckets on my 40 coupe. The previous owner had gutted them to use LED style taillight panels. I wanted to go back to the socket style only using LED bulbs (United Pacific.) I ran across a set of replacement...

Looking for a decent quality 37-39 car/truck windshield frame. Glass not important but must be in minimum to no rust condition. Please let me know what you have. Thank you.

Dear Pete, Would you be interested in selling this windshield? Please let me know, also your location if reasonable to indianapolis I would pick it up. Thank you so much. Al Seidel

Dear Ford Barner's Thank you to all for your replies. Always appreciate the knowledge in this forum. Also really l enjoy the tongue in cheek play many offer as well. Merry Christmas

Dear Ford Barn, My 1939 Car Windshield Frame is starting to deteriorate. Namely the center post at the bottom dividing the two windshields. I have found another frame that looks similar but is not. The split separating the two halfs is much higher up on the replacement compared to the one...

Dear Early V-8ers, I am having a problem with the inside door handle latch on my 1940 coupe. When I try to raise the door handle to lock the driver's side door the handle feels very weak. The door shuts fine and releases as well. I assume a spring has weakened or broken on the inside latch...

Dear Ford Barners' Looking for a set of 57 Lincoln Premiere hubcaps. A second option would be a source to restore the center caps. Any leads or information would be most apprecaited. Regards, MrPhat40