Recent content by Mrowlett

Got it! Be creative, think outside the box, make a L shape tool. Apply many thumps!

Hello again, I need to replace the rear axle seals on my 29 model A. I've removed the drum and snap ring. How do I remove the old seal? The center hole is to small to get an angle with a screwdriver to drive it out without bending it. I've tried to get it out with a driver between the bearing...

Thank you all, I’ll get the fitting for my grease gun. I really like simple.

I have a 29 chassis that I want to grease the front end. The grease zerts are not, as some of you know like the modern ones. Do I use a regular grease gun or is there a fitting I need to get?

I have a 29 chassis that I want to grease the front end. The grease zerts are not, as some of you know like the modern ones. Do I use a regular grease gun or is there a fitting I need to get?

Thanks for all the advice guys, really appreciate it.

So the higher I lift the wishbone the more castor I get? Or is it like alining the front end?

Wondered about that

55-60 mph

I built a crossmember for the wishbone, not knowing how much pressure to put on it I raised it till it seemed firm, basically they are close to level. After I did that I could go 10' before sideways wheels.w

Hello, could use some help. I have a model A chassis, no engine, trans, steering wheel, that I have used to build a mockup delivery truck to be used as a food concession. I am going to tow it like a trailer, there is the problem. When I hook it to my pickup and move the front wheels go sideways...