Recent content by mOSkit

Sorry all. This particular block is EAB 239. Only one cylinder was sleeved before, and this sleeve had water again. I have measured the other bores and they are very ok. I have emailed egge to see if they can supply .100 pistons. If so, the same type of new sleeve will work without an issue

Hi Guys I`m trying to save a block and not pay to sleeve the entire block. I have one rotted cylinder that was already sleeved before and considering the wear and all the bores being bored to .083 i`m considering to bore 7 cylinders to accept .125 pistons and fit one sleeve. The question is...

I need the cam gear bolt pattern. The bolts are offsetted so the gear can only fit one way on the cam. Very difficult to take those measurements especially that the tdc dot and the bottom bolt hole are off somewhere like 20degrees

Do you refer to this sheet?

Guys I appreciate your feedback. As per original post, I'm not looking for financial profit. I want it to print it for my self, i actually use it on regular basis (paper printout attached to cam gear) and hence I have my own 3d printer I thought it will be cool to go rigid version. I understand...

Yup, this is mine. i want to make it so you dont have to spin the crank when rebuilding the engine to adjust the valves, hence i need bolt pattern.

Hi guys I want to make valve lifter indexer to be available to print on 3d printer but i need the bolt pattern including all hole angle from the marking point so it will be accurate. Does any one may have some info?? I promise the design to be free to download for your own 3d print. Thank you

3/8 pipe is it a 3/8npt?

Gents 2 questions 1. what is the water temperature sensor port thread size on 49-53 flathead? 2. is the cooling system sides separate?? i mean left side is separated from the right or did they bypass somewhere? thanks

Hi guys, sorry for late response. For some reason i`m not getting any email notification. Yes, that dimensions are nominal. I could not find any sleeve to be 6.5" tall. Hence i know now that the overall lenght of the bore is about 6.5" as well. I was hoping to leave that 1/2" step before the...

Greetings Hello from over the pond. I need some information regarding cylinder sleeves.Especially length. I know that MAC`s sell sleeves for flatheads but i also have local supplier here in uk which should save me few £. So, can any one tell me if i can use those available locally?? Sizes...

Hi guys. Does any one know the right sequence (valve lift/cylinder) for adjusting valve lash? I don't want to keep the crank spinning to see which one is in bottom position. I use Johnson style adjustable lifters. Thank you