Recent content by Monty2719

Seeking complete top mechanism for Merc Convertible Top covering material not important.

I am setting up an engine for my '32 Vicky. Motor is '51 Merc flattie. As we live in Florida where summers are HOT the wife wants air conditioning. The motor has the small crank pulley and I want to run the truck water pumps with the foot to mount engine ( not using car pumps) I see all kinds...

I have 3 wheels that were sand blasted and grey primered. Good lug holes and spokes. One was pretty pitted and blew thru but other two are pretty nice,

Original carb. Came off a motor we used as a bassis for our rebuild. Its complete but dirty and moving parts are stuck and I have not attempted to clean up or free any of it. Concider this a good rebuild able unit. Sll linksge are attsched including the one to the choke at lower part of...

Original steel fender. We sandlasted with low pressure and filled a few dings and replaced the wheel well with a Brooksville one as original was thin and badly pitted. Fender has been primed and blocked a couple times and could probably use having that done again. We have done this on both top...

4 Very nice wheels. When I found them they had no rust and one coated of red paint. I sent them out and had them bead blasted them primed and they are painted urethane black with hardner. These are 17" diam.

What is correct length ? I have a pr that measure about 4 1/2" and a pr that measure about 5 1/4"..

What is the widest tire that I can put on these rims ? I have a set of 4 that are perfect and they would look very nice on my '31 ford Vicky. These are 5 1/2" bolt circle rims.

I am looking for a decent frame for my Vicky. I would even concider a rolling chassis but all I really require is a good frame. Hopefully within a days drive of Rochester NY.