Recent content by ModelAMitch

Your correct. I did not install it in one continuous piece. I cut it and installed it in three pieces. One between tank and windshield frame. And one on either side where the tank meets the cowl. After installing in three pieces and still having a difficult time with lots of cursing during the...

I used strips of tape to hold the welting onto the top of the tank. I slid it in place, and moved the welting around with a small flathead screwdriver through the holes in the windshield frame. Got it lined up pretty good that way. When your done you can cut off whatever tape is exposed on the...

You could get a small bolt with the same thread size (bring the plug with you to the hardware store) and use it to temporarily hold the pump in place.

Wow.. lucky nothing worse happened! It looks like my ignition cable has seen better days but the car has no troubles starting and running, it just backfires occasionally while driving. However, the ignition cable is on my to do list for this winter.

Very interesting.. I’ll certainly give that a look once I get the carb off again thank you

I have a marvel carb with the GAV turned out almost a half turn.

Thanks rotorwrench. With the fuel line off the carb and gas valve turned on gas is flying out of there pretty quickly. I’d say there is sufficient fuel flow. So I guess maybe I’ll take the carb off and give it a good clean again. I’m getting really good at taking this carb apart..

I will do this first and see if anything changes. Thank you!

Interesting, thanks Ill look into this. Ill play with the GAV next time Im driving. Also, my ignition cable was electrical taped into the distributor from the previous owner. Sounds like this could be a problem aswell. I have a bit of a leak at the exhaust clamp at the bottom of the header, I...

Ive had my tank off to clean the rust out of it, have cleaned my carb recently and I have an inline fuel filter I change frequently whenever it gets a bit of sediment in it. I don't think Ive reached 30mph since changing the timing gear haha. But I have had my distributor apart and have not...

Hey guys, question here about my car backfiring.. I haven’t driven my A too much since owning it and my timing gear went. I replaced that and did a bunch of other things. Now it’s running and I’ve driven it twice since my repairs and it’s backfiring, mostly on downshifts but sometimes during...

This one is slick! Hardly noticeable it looks like. I don’t really want a big bulky piece of plastic hanging off the dash..

Thanks Marshall for all the info! I’m glad it’s running and now just fine tuning. Before my large list of repairs started, I had my GAV set a little less then a half turn opened and it seemed like the car liked that the best. I’m at that same spot now, but I have messed with the air and idle...

So I got my battery tested, no good. I got a new one, installed it and it fired right up. It runs much better now since I re timed it, but it isn’t 100% yet. The idle adjustment screw is turned in quite far and with the hand throttle all the way up it wants to stall. I drove around the block...

This is a good question, I’m curious as well… anybody care to chime in??