Recent content by mill48

No, I'm talking about the grease insert on the left of the water pump. I can't seem to upload a pic from my pc.

It's not a leakless water pump. I'll take a picture in a bit.

Hello all. I have a question concerning a leak at the water pump insert. I just recently discovered this. Does anyone here have a solution?

I eventually found out that what I thought was a new light was no good. I say that because I had a spare that I connected and the light came on immediately. I thank you all for your great advice.

No, I was testing the ground. I couldn't get a proper reading because the leads were too far from the battery.

Yes. It appears to be giving me the battery reading. I tried to use my multimeter but apparently I'm not using it correctly. I have it on the ohm settting but I don't know which setting to put it on. In either case the number doesn't change from the time I turn it on. I am clipping to the...

I tested the voltage with a test light and got from 11.9v to 12.3 on the headlight connections. The reading on the ground was also 12.3. Is the ground good or bad with such a reading? I had the alligator clip attached to the positive terminal on the battery.

Thank you both for your great advice.

The headlights have a crossover from one light to the other. I am about to do a voltage test with a multimeter.

I apologize. I do have the headlight grounded to the frame.

Here is the link to the exact switch that I bought and installed. There are four wires going to four terminals. I will still provide pictures showing the connections. https://www.dashswitches.com/products/3-position-compact-fused-headlight-switch-black-bakelite-domed-knob-series

I installed what was in the car and both lights were working. I'll have to wait until it's daylight again before I can take pictures. As soon as I can, I will upload some pictures. Thanks for the quick response.

Hello fellow members. I have a healight problem wherein one works and one doesn't. The headlights were installed new at the same time. I decided to take the switch down and noticed that the copper that holds the fuse was broken so I ordered another switch and installed the new switch that came...

Thanks guys. I tested my horn and it works. Your knowledge is greatly appreciated.

What's the name of that wire and where can buy it. I know I can get the bullet ends at almost any auto parts store.