Recent content by Midget #77

Any body know where I can get the bushing that fits in the water pumps? Thanks

Great idea ... I'll have to go to a short bulb. Thanks

Thanks fellas, looks like I'll have to be creative. Had hoped there was an easy fix. I have the long spout on the gauge, so I may have to find the shorter one. Let me know if you know of anyone that just sits around and makes these.

My 17 stud heads do not have anywhere to put the water temp gauge line. The 90 degree spouts are bolted on, so could be removed. Any ideas on finding a way to install the gauge? Had hoped for a find under "wanted", but no luck. No where on the block that I can see of. Thanks

I have Edelbrock heads 17 stud, I need a 90 degree spout that will accomodate the water temp gauge line. Single output on head. V8-60

Must be why everyone is having such a hard time with this. That GM tube is exactly what it looks like. When you set in a midget, you really want all the protection you can get from a spinning drive shaft and ujoint .... it is right where the family tree would end. Thanks for all the help!

If you click on my profile and look at my album, second pic, you will see a tube like the one I need. Thanks

What I need is the long tube that comes out from the halves that cover the u joint. Probably the first thing that gets thrown out. thanks

Need the v8-60 drive shaft torque tube from the back of the ******. Should have a seal in the end towards the rear wheels.

Need the torque tube U-joint ball housing for a V8-60.

Thanks, bought it!!!!:)

Thanks ya'll found one on ebay!

I need the U-joint torque tube cover or housing cap: V8-60 ****** Inner B4513 and Outer 48-4520A. Know of any source?

Know of anyone that still supplies or has the inner and outer housing caps? thanks

Need the torque tube cover, both inner and outer that cover the u-joint at the end of the ******.