Recent content by Mark29idaho

Thanks for the thoughts... I talked with them today, they are looking, I’ll know tomorrow if they have any.

I also am missing one of these pockets, and it seems they are impossible to find. So hang on to yours. I think I’m going to have to fabricate mine.

I have a 29 special coupe that is missing the cup that the striker plate sits in. I have looked everywhere for a reproduction, can’t find one. Does anyone have an extra drivers side pillar or center section?

Special coupe

Does anyone have the piece that the striker sits in on the b pillar. I have inherited a nightmare and mine is missing this piece. I have looked everywhere but they are apparently not reproduced.... Perhaps someone has an extra drivers side pillar? By the way mine has been painted, any ideas how...

I removed the risers and now concentrating on the body mounting and aligning Kuna is as close as I have found Thanks

Yesterday I thought I should mount the body to the frame so the wood would fit like it will at finish. I placed the wood blocks and got everything aligned. But, the rear body support, a riveted on riser attached to the rear bumper is too tall. It’s holding the car about an inch above the support...

Thanks for the welcome

Has anyone done their own install on the wood and vinyl top? I have inherited a partial done 29, so I am putting a jig saw puzzle together with out any help. I would love someone who had done this so as I run into the problem spots... I could have someone who’s gone thru it before... Photos...