Recent content by Mark DeRoseau

Aries fit with a Borla or magnaflow sound...

Welds

Third

Second

Fresh tig job

Aries head stock

This

Aries. Will sell the correct head stock. Regular or stainless.

Since no one has answered you question, helpfully... I will hopefully clarify. There are a select few of ford barners who have all the prints. They will not tell you where to get them or how much they cost. (very helpfull). They will however tease you with the fact that they have them...

Test

James, I'm confused.... When I go to your website, it infers that you don't offer counter weights added to a crankshaft. It says, and I quote " why run a welded up, counterbalanced, 80 year old crank that is ground 10/20/30 or even 40 thousands undersized that cost up to $650 when for $1025 you...

Chris, he doesn't build to the prints as he said in his 1st post on the forum on 6/17/2010... He builds to "originals" he had on hand. Wait, but then he said he builds to prints...and Brent says you should expect to do work on parts you buy from vendors... Yesterday "the brassworks" said this...

Bet they used the scale to tram the head in as well, before they put their last good insert in that bear claw. Actually don't think there was one good insert in that thing.....

Replace the starter drive to a modern Bendix https://www.snydersantiqueauto.com/modern-starter-drive

Love the golf analogy..... But I think the point is that most are asking, how far to clear the trees for the dogleg left. And the answer isn't a 5 iron, or a 3 wood. And definitely not read the PGA's Rulebook. It's about answering 210-230 yards out, or not at all.... Too many people see others...