Recent content by Loyd Nix

Thanks guys I will start with removing the radiator and see what I have for room and if need be I will remove the rear motor mounts and jack the engine. It is always something isn't it?

Is it possible to change a crank pulley without pulling the engine?

I have an alternator as well and will keep driving and see if it "normalizes".

I own a 29 Sport Coupe. I left the parking lights on overnight and the 6V battery went stone dead. I put a charger on it for 5 or 6 hours and charged it enough to start. The ammeter showed it was charging more than 20 amps and finally after several trips around town the reading went down to 10...

I flushed with almost a gallon of paint thinner with no luck.

Not in the drained oil.

Thanks guys. I will try all suggestions this weekend.

While reinstalling the shifting tower on my '30 Tudor I dropped a washer from one of the bolts into the transmission case. I drained the oil out of the case but I cannot see the washer or feel it. I have tried a flexible magnet but no luck. Anyone else made the same dumb mistake? Is there any...

That's the fellow! Thanks

Does anyone know if the fellow in North Carolina still does speedometer rebuilds? I used him several years ago and was happy with the work and quick turnaround. I can't find his name or phone number anywhere.

Finally got the 29 Sport Coupe running. It was something in the distributor. Very labor intensive (for Me anyway) but followed the step by step and finally chased it down. Thanks guys.

Ron I will try that. Thanks

Yes, the car ran previously and I do have lights and horn. I went thriugh the distributor to check for shorts, replaced and regaped the points and replaced the condenser. I removed the rubber insulator from the coil(if that was what it was supposed to be) and jumped across the terminals in the...

I will try that in the morning. Right now I am going to watch the baseball game.

I replaced the coil. It came with a small sheet of rubber which I assumed was to insulate the coil from the firewall and clamp. Was I mistaken and the coil needs to ground to the firewall and clamp? What was the sheet of rubber included for?