Recent content by loubob

I ran 38psi on my '30 coupe and it was like driving the car with power steering. The ride was excellent!

TCP Global!!!!!

Any/all packages I send are only sent FedEx or UPS. NO problems.

I had to sand down the brass contact points to get the switch to work. It may not be the right thing to do but it was for me. Sand a little then try the switch. Repeat as necessary to get the switch to work.

I received 2 of the new/updated LogoLites LED headlight bulbs +ground last Saturday. NO FLICKERING! That made my day. NO load equalizers necessary. I also have LED tail/brake lights. No turn signals or cowl lights. Logolites is waiting on a shipment but had not received a date from manufacturer.

TCP is excellent. I have had several cans of spray paint made from their paint with excellent results.

shew01: If I said load resistor it was my mistake. I apologize. Wiring harness is new. I do not believe it is in the switch body as a lot of other owners are experiencing the same problem.

I purchased the LED bulbs from LedLight.com. After install they flickered every time I turned on the low beams but not on highs. Called Ledlight and was advised hat I needed to install a Load Equalizer to each headlight. They stated that because of the lower current draw, the system sensed it...

Thanks to all who replied. I "played" around with this most of the day. I installed load equalizers on each low beam wire. No change. Installed a different set of LED headlight bulbs. Still no change. Both sets of LED bulbs looked identical to me. So, I installed one of each and NO flickering. I...

I have installed LED bulbs in the headlights. With low beams turned on the lights 'flicker.' When the high beams are turned on the 'flickering' stops. I installed load equalizers on each low beam wire and 'flickering' remains on low beam. I was told to have a good ground. My question is where is...

You may get that information by calling one of the A parts suppliers(Berts,Snyders, or Brattons)

Kevin: The Santa Anita Model A Club made an EXCELLENT dvd on the Flathead Ted Brake kit/install. Order it from Snyders. Part # A-18801-F. Watch it several times to get familiar with the parts/names.

Bob: Did you have to install load resistors on the low beams to prevent "flickering"? Where did you buy the led bulbs? w

What is contradicting is the Diablo cd shows the cotter pin placement on the outside. Loubob

Thanks. I will switch the cotter pins tomorrow.