Recent content by lee34

  1. lee34

    JB Weld penny for heat riser block offs?

    RE Penny block off . You have to use old penny the new penny is not penny is made cheaper and not as good, [ like a lot of new parts} l l Lee34
  2. lee34

    33/34 dips in cowl for hood support.

    The cowl (dents) are much more noticeable than I see in your pics 33 Ford had flared place on the radiator.In the same area the 33 did not have a screen in the cowl vent.The screen was approved for production the last week of Feb.All together there were over 60 changes from the 33.The serial...
  3. lee34

    Open driveline phasing ?

    There are some vehicles that have independent rear suspension that use 2 u joints for each axle plus u joints on the drive shaft.(Total of 6) Each u joint can be installed 180 degrees off. when installed out of phaze operation is greatly affected more so at slower speeds I think most drive...
  4. lee34

    40 wheel out of round who repairs this? KY

    L78 There is a very good place in Louisville.They shaved my tires on the car..My wheel was a spoke wheel .They also balance your tire on the car (do not remove hub cap or any thing)They balance and check high speed operation as well.They are located on Poplar Level RD. The business name is...
  5. lee34

    1933 vs 1934 Front Bumpers

    The 2 inner holes on 33 are 22 in apart and 34 are 26 in apart .They can be used on both years if same year brackets and bumpers are used together (not correct for year for restoration) Lee34
  6. lee34

    Head lites

    The reflectors that Drakes sell (possible others) are different than original.The problem seams to be worse with the h4 type bulbs.They are bright enough just not focused.I purchased the kit from Drakes and only changed the reflector,I did not change bulbs so I could see if the reflector was the...
  7. lee34

    Head lites

    I had a 34 sedan with original lense and h4 bulb with same symptoms,I purchased Drakes reflector kit and now I can see I no longer have to use Braille to drive at night Try to explain to your wife your reflectors are worn out and you are spending over $100 to get new ones.(but worth it) Lee34
  8. lee34

    Loud turn signal flasher

    Jim;You can get one from RON FRANCIS WIRING 800-292-1940 www.ronfrancis.com Simple hook up.2 wires.Does not even need to be grounded.A little on the loud side.I am sure there are others out there but this works for me.Good luck lee34
  9. lee34

    Please post pictures of 1933-1934's here

    Owned this car for 52 years...Think I'll keep it...only owe one more payment..LOL! Lee34
  10. lee34

    POOR Brake Lights ~ Thought I Fixed Them ~ HELP!

    Have you checked to see if the running lights and brake lights are switched so the proper element is not receiving voltage as needed ? lee34
  11. lee34

    1934 repo bumpers.

    The original 33 & 34 bumpers had a ( 0 ) stamped on the back side. sometimes only a partial of the 0 made contact leaving a ( c ) . Both of mine are stamped on the left side (while looking at installed bumpers) lee34
  12. lee34

    Who Knows Potter Trunks ?

    Your trunk may be a trunk that was made to go on top of a luggage rack.There was several different manufactures for the trunks.In 1934 the Potter trunk was was the only one authorized by Ford.Later models of Ford had the trunks built on as part of the body .(Hump back).I think Potter went...
  13. lee34

    33 or 34 cowls

    The 34 has a notch on top of the cowl for the hood to be held when open and 33 do not,34 has a screen in the vent and the 33 does not.If the dash is still attached all the gauge are mounted to a panel and that panel is mounted to the dash only on the 33,The 34 have a hole in the side where...
  14. lee34

    Help on noise please

    fREDERICK Checking a cylinder by pulling a plug wire off can cause damage to electronic ignition components .You can use a plug wire that is pulled off and attach it to a plug touching the motor no problem.A plug wire pulled off and not touching a ground (motor or frame) can cause the coil...
  15. lee34

    Drake grill fitment? Need to know

    Like alchemy stated they all seam to be different Look at the tie bar at the bottom ,most are not uniform lee34
Back
Top