Recent content by lasallefellow

These are the sun visors that have the correct brackets to match the double molding around the roof on the inside of the car. I have two and the price is for both. I don't know how to post a picture, but send me your contact info and i'll send them to you. Bob

I just had one fixed in my 54 merc. Was really satisified with the work and especially the turn around speed. Price was good also. Try mrgrandprix@att.net He is in Wayne NJ

1954 Mercury Sun Valley sun visors and brackets. Are these being repoped or would anyone have a pair to sell? They are different than the Monterey hard tops, correct? I'm also wanting to find some panel board material to make the trunk lining boards. This suff has a pattern of little squares on...

My old wiring has capacitors on all of the sending units that I mentioned. I am putting in a new harness, what value were these and are they really necessary? I'm doing a restoration and it is still going to be 6 volt. Thanks

If you still have the sun valley, could you send pictures? cbunnell@comcast.net

Tomjc While you are looking for the interior trim pieces can you look for the bracket that holds the fan for the heater. It mounts to the inner fender on the pasenger side and the fan slips into it. Thanks

Still have the interior trim pieces?

I just saw your reply, save that for me please.

This car is a 2 door hard top, and I need the painted inside pieces that attach to the door just above the door panels. Just the left one in the front and the right rear painted one in the same position only in the rear seat area, along the side not back by the rear window. I also need a lens...

I"m looking for the right side interior door moulding for a 1954 mercury 2 door, also need the left side interior moulding for the back seat along the rear window. The car is a sun valley, don't know if that makes a difference. I bought the car in an auction, all apart, at Monticello, Indiana at...

I need one 1954 mercury parking light lens. Thanks for any help.

Can anyone tell me how the stainless side strips that go down the belt line clips work? I have new ones and they don't seem secure at all. I think the factory must have had problems also as the original clips have a whitish hard stuff on them on the body side of the clip. I'm about to put the...

did you sell your carb?

I have a complete rear end for a 40, even has the spedo gear. I'm located in Lafayette In. Would take 150 for it. Let me know if you are interested and I can take some pictures and perhaps pick a time for you to come and get it. cbunnell@comcast.net