Recent content by kwisor

Thanks for the help been under my car all day finishing up my new clutch install Kevin

I finished putting car back together today. Clutch works like a charm.The pedal is tight no more slop.Wish I done it sooner. It took me over two weeks by my self. I had a wench I made a bracket for to lift the trans or I would have never got it in by myself thanks Kevin

Order the new modern adj rod you can adjust without removing the pin I just put one on my car and was a brease to adj Kevin

hello all thanks for the replies i did not think i could adj the fingers with the transmission in the car. so today i pulled the ****** adj clutch found some bad clutch shaft bushings replaced them got it back together. i replaced the cross shaft bushings. all i have left to do is attach the...

Re: need help totally confused clutch finger adj hello i found out what i did wrong i set my rouler up in correctly and now will have to re adj the fingers in the car sounds like fun kevin

Re: need help totally confused clutch finger adj everything i have read or watched has not helped kevin

Re: need help totally confused clutch finger adj i have watched that video but still confused if i adj it to 3/4 i would not get bearing to touch fingers. or is this measurement from the clutch disk to finger? kevin

Re: need help totally confused clutch finger adj yes i adj it after i put it on the flywheel it has taken me almost two weeks to get this far i am doing this with no help thanks kevin

hello i just put a new clutch disk and pressure plate in my 30 tudor. i adj the finger to 5/8 and went to adj the peddle . i have the peddle adj as far as it will go . when i Engauge the peddle it dose nor seem to disengage the clutch all the way the through out bearing seems to barely move...

hello i am replacing my clutch and need to replace throw out bearing my question is how do you remove the bearing from the hub and put the new one on i do not want to damage anything 30 tudor thanks you kevin

hello all i need sme help this is not a foed question but a 1935 ply question i am working on my father in laws 35 plym i have it back togeather an has beed running great the other day i drove it and when i turned it off it would not start a few days later it starts right up drive it rund grat...

i had this happen and the arn on the clutch shaft cracked i could not see it but no clutch i foud it put new one on fixed kevin 1930 Tudor

thanks i will give it a try kevin

hello no i do not know how to do a leak test thank you kevin

hello redmodel t i have the copper gasket buti will replace it has been on there a long time. when i turn it off it will back fire thank you kevin