Recent content by Kustom Komet

I got the tubular set from Snyder's a year ago, the kit was easy to install. The ride and handling is very nice. If you aren't too concerned about an original appearance, this is a good option.

52, got my A 1.5 years ago but my Dad had a couple of them in the early-mid '70s so the bug has always been there to one extent or another.

Thanks Gentlemen. I'll get the mirrors on order and modify the right side. -Mike

I need a set of mirrors for my roadster, pillar mount type. Many vendors sell the familiar units: https://www.macsautoparts.com/ford_model_a/model-a-ford-windshield-stanchion-post-mirror-open-cars-only-polished-stainless-steel.html But some say these are for left side only. Is there any reason...

Account suspended message at that link.

Sal, It's got a mild 289/C4, a '63 Falcon V8 8 inch rear, and '65 V8 front suspension/steering with Granada spindles. Fun little cruiser, and just a bit better than the bolt action six banger it came with.

Bolt action - 3 on the tree shifter

I got raked over the coals by NAPA, they wanted $37 , I talked them down to $27. Live and learn. Brick and mortar keeps complaining about how online is killing them, perhaps if they weren't so prone to extortion...

It's a '60, and I've had it for 30 years, but restored/modified it in 2007.

That's what I should have done, especially when I found out what the new seal cost!

How did you like pulling that inner grease seal? I had to wail away on one of them for 8-10 minutes like a monkey with a slide hammer. And they have a lock ring as well? Didn't see the need for that!

I'm pretty sure that I used a upper or lower ball joint nut from an early Mustang/Falcon V8, which should make the search a bit easier.

The black one?

https://www.youtube.com/watch?v=lC_zIvb1Yuo&feature=youtu.be&list=PLav-W1BC-Nj-T6al6Pk5bcpNJQdDfO5H8 Not sure why it's listed under "comedy"... I didn't do the hydraulic conversion. It was done long ago, all home brew stick welded brackets and whatnot. They did a good job, but the car had...

Great success! A friend came over and saved the day with a 40 year old Craftsman die set with the proper die wrench and die, and we followed the Fullraceflathead Youtube example and fired up the Henry Ford 40 horse lathe. Went very well, and not too tricky. I found a nice old tall...